Home | Products | Manufacturers | Contact Us | About Us

The Air Handlers we carry all come with the standard components listed below.

The Basic Cabinet consists of a fan section and a coil section with a double wall drain pan. The housing panels are die formed from mill galvanized steel and insulated with 1"-3/4 pound density mat faced fiberglass insulation. All fan sections have hinged and latched access doors. The unit pictured here has a fan and a coil section.

The Coil Sections cover a wide range of heating and cooling requirements. Side, top, and bottom panels are 16 gauge mill galvanized steel. All coil sections accommodate either small or large face area coils.

All units have single, double width, double inlet fan wheels for quiet performance and low energy consumption. Single wheels eliminate the problem of unequal loading, which is characteristic of units with multiple wheels. Also, the expense of a "pants" type duct connection is avoided. Sizes 03 through 41 units have forward curved and size 50 through 75 units have airfoil fans as the standard.

Finally, each unit has a motor mount. Heatcraft Products puts the motor inside the fan section cabinet. It is mounted on a heavy gauge steel slide rail base. There are several advantages with internal motor location. It eliminates the need for a bulky belt guard. Another advantage is that Heatcraft Products balances the factory mounted motor and drive components, which can eliminate additional balancing at startup.